Five Tips to Make the Most Out of your Miter Saw When Using It for your Furniture Projects

If you are like other people, you will want to use the miter saw when building DY furniture projects. Before firing up the saw or choosing any tool, always think about safety. Make sure to read, understand, and follow the instructions that come with the tools. Also, always wear safety glasses, hearing protection, and a quality respirator.

Below are other helpful tips to ensure you get the most out of your mite saw:

Tune It Up for First

Although best miter saw is set at the factory to ensure proper alignment, some of its parts could be misaligned during shipping. In fact, miter saws can come out of alignment with regular move or use. You will want to make sure your saw is cutting square. Tuning up your miter saw will make sure the blade is square to the table and the fence is square to the blade.

Ensure you Use Sharp Blades

A saw blade that has more teeth can produce cleaner cuts and a blade that has fewer teeth will product rough, choppy cuts. When cutting DIY furniture, use blades with more teeth. Unfortunately, some miter saws are equipped with a saw blade that is better for cutting studs than furniture pieces. But, you can upgrade your miter saw by installing a new blade.

Leave the Pencil Line

Remember that you can always cut the wood shorter; however, you cannot put it back on. That is why you must leave the pencil line when making cuts using a miter saw. This will let you fine-tune the cut when you have to come up with a board that is a bit shorter.

Wait for the Blade to Completely Stop

Cutting a board and raising the blade with the saw still turning will leave the blade cutting the board twice. It is expected to cut once when you lower the blade and raise the blade. When you cut the board twice, its measurement can change. Since you have to leave the line, allow the blade to come to a complete stop when cutting wood with a miter saw.

Create a Stopper when Making Repetitive Stops

Projects such as the outdoor coffee table, garden cabinet, or beverage table have a lot of repetitive cuts. Instead of measuring and cutting every piece, consider measuring once and setting up a stop. You can use a piece of scrap wood clamped to the miter saw as the stopper.

Comments are closed.